MakerBot Introduces Fun New MakerBot Filament Colors

Related: News

MakerBot Introduces Fun New MakerBot Filament Colors

It's almost Halloween, and MakerBot is introducing three new MakerBot PLA Filaments that might add a little spook and some glow to the Hallow's Eve festivities. The new MakerBot PLA Filaments are available online at makerbot.com/filament and in the MakerBot Store in New York and are MakerBot Glow-in-the-Dark PLA Filament optimized for the MakerBot Replicator 2 Desktop 3D Printer and MakerBot Warm Gray and Cool Gray PLA Filament.

Made with a special phosphorus dye, MakerBot Glow-in-the-Dark PLA Filament works with any light source and glows a ghostly green in the dark. The intensity of MakerBot Glow-in-the-Dark PLA Filament's glow depends on the intensity of the light charging it: the stronger the light source, the better. No sunlight is required to power-up the MakerBot Glow-in-the-Dark PLA Filament - any light source will do. Just keep in mind that charging the MakerBot Glow-in-the-Dark PLA Filament takes around two to three minutes depending on the intensity of your light source. Once the MakerBot Glow-in-the-Dark PLA Filament is all powered up, try printing out a spooky print like a large troll statue from Thingiverse super user colinfizgig or this fun Witch's Hat by MakerBot. The mesmerizing allure of the MakerBot Glow-in-the-Dark PLA Filament can be brought back again and again by just renewing the light source for a few minutes.




More On: News



Comment & Share


Subscribe for News & Specials